Loading-Bar
Zinnos
Sitemap
NMEA-2000 Engine Motoring System

Products

Engine/Vessel Monitoring

Products > NMEA 2000 Products > Engine/Vessel Monitoring

■ J2K100 J1939 to NMEA 2000 Gateway

● Converts J1939 Data to NMEA 2000® Data for Display on Compatible Equipment
   (Furuno, Garmin, Maretron, Raymarine)
● Attaches to Any J1939 Engine, Transmission, or Genset
   - Caterpillar, Cummins, Detroit Diesel, John Deere, Kohler, Northern Lights, Onan, Perkins, Steyr,
     Volvo Penta, Yanmar, etc.
● Converts Following Data
   - AC Generator Current, Frequency, Voltage, Tach, Hours, Coolant Pressure &Temp, Oil Pressure &
     Temp, Fuel Rate, etc.
j2k100 nmea2000 j1939 to nmea2000 gateway
Click the image for the details.

■ EMS100 Analog Engine Monitoring System

● Converts Analog Data to NMEA 2000® Digital Data
● Converts Following Data if Engine is Equipped with Sensors
   - Tach, Hours, Water Temp, Oil & Boost Pressure, Volts, Trim
● Converts Engine Alarms if Engine is Equipped with Switches
   - Fuel, Boost, Coolant Level & Temp, Oil Pressure, Exhaust Flow
● Plugs Directly into Engine Wiring Harnesses
● Used With or Without Analog Gauges



ems100 nmea2000 analog engine monitoring system
Click the image for the details.

■ TLA100 Tank Level Adapter

● Adapts Resistive Tank Senders to NMEA 2000®(Royce, WEMA, etc.)
● American(240-30 ohm) or European(10-180 ohm) Standard Compatible
● Can be Calibrated for Irregular Shaped Tanks
● Can be Used With or Without Analog Gauges
● 16 Point Calibration
● Supports All Tank Types
   - Fuel, Fresh Water, Waste Water, Live Well, etc
tla100 nmea2000 tank level adapter
Click the image for the details.

■ RAA100 Rudder Angle Adapter

● Adapts Resistive Rudder Senders to NMEA 2000®
● American(240-30 ohm) or European(10-180 ohm) Standard Compatible
● Can Be Used With or Without Analog Gauges
● End Point Calibration for Different Rudder Stop Angles

raa100 rudder angle adapter 
Click the image for the details.

■ ACM100 Alternating Current Monitor

● Monitors AC Sources and Outputs Data to NMEA 2000® Network
● Monitors Utilities(Shore Power), Generators, and Bus Power
● Provides Voltage, Current, Frequency, Real Power, Reactive Power, Apparent Power, Power Factor,
   and Imported & Exported Energy
● Supports Single Phase and Three Phase Systems
● Sealed Waterproof Enclosure
acm100 alternating current monitor
Click the image for the details.

■ DCM100 Director Current/Battery Monitor

● Monitors DC Sources and Outputs Data to NMEA 2000® Network
● Measures Voltage & Current of any DC Source or Load
● Advanced Battery Monitoring Including Temperature, Load & Charging Current, Terminal Voltage
● Computes Battery State of Charge, and Time Remaining
● Hall-Effect Sensor Slips Over Wire – No Connection Breaks as with Shunts
dcm100 nmea2000 direct current battery monitor
Click the image for the details.

■ SIM100 Switch Indicator Module

● Monitors Switch Closure Devices and Broadcasts Status Over NMEA 2000® Network
● Detects and Reports Opens, Shorts, etc.
● Works with Maretron Supplied Detectors
   - Heat, smoke, bilge water, carbon monoxide*, LP Detector*
   - Magnetic switches, glass break, door, hatch, portholes, etc.
sim100 nmea2000 switch indicator module
Click the image for the details.

■ RIM100 Run Indicator Module

● Monitors Both AC & DC Circuits and Reports Running Status Over NMEA 2000® Network
   - Manual or Auto Switched Loads
● Indicates Whether or Not Various Devices are Running
   - Bilge pumps
   - Winches
   - Running Lights
   - Transfer Pumps
   - Exhaust/Intake Fans
rim100 nmea2000 run indicator module
Click the image for the details.

■ TMP100 Temperature Monitor

● Monitors Up to 6 External Temperature Probes and Broadcast Data Over NMEA 2000® Network
   - Four Channels of Thermistor Probes(-4°F to 176°F) and Two Channels of Thermocouple Probes
     (32°F to 1652°F)
● Probe Applications
   - Cabin, Engine Room, Equipment, Air Duct, Tanks, Exhaust Gas Temperature (EGT), etc.
tmp100 nmea2000 temperature monitor
Click the image for the details.

■ TLM100/150/200 Temperature Monitor

● Ultrasonic Tank Sender with NMEA 2000® Interface
● 1/8” Depth Accuracy(-25°C to 55°C)
● TLM100 40” Depth Tanks
● TLM150 25" Depth Tanks(only Gasoline)
● TLM200 104" Depth Tanks
● Can be Calibrated for Irregular Shaped Tanks
● 16 Point Calibration
● Supports All Tank Types
● Fuel, Fresh Water, Waste Water, Live Well, etc
● Non-Displacement Hulls Require Focus Tubes
tlm100 nmea2000 tank level monitor
Click the image for the details.
Copyright 2017. Zinnos Inc. all rights reserved.
435-1, Haeyang-ro, Yeongdo-gu, Busan, 49111, Republic of Korea
T. +82 51 404 3454    F. +82 51 404 3421    info@zinnos.com    www.zinnos.com    www.digitalmarine.kr